EventCntr8 Properties Bean documentation

Bean name - Name of the bean.
Counter - Counter register of the timer.
Interrupt service/event - Bean uses the interrupt service for the counter function.
- Interrupt - Interrupt vector invoked from the timer (for information only).
- Interrupt priority - Priority of the interrupt associated with the timer.
Event - Event settings.
- Counter input pin - Counter external clock pin.
- Input pin signal - Signal name of input pin.
- Pull resistor - Setting of pull resistor.
  There are 6 options:
  - no pull resistor: Input without pull resistor is required
  - pull up: Input with pull-up resistor is required
  - pull down: Input with pull-down resistor is required
  - pull up or no pull: Input with pull-up resistor is preferred, but no-pull is acceptable
  - pull down or no pull: Input with pull-down resistor is preferred, but no-pull is acceptable
  - autoselected pull: There are no special requirements for pull resistors
- Settings no supported for HC08 only.
  - Edge - Type of signal edges that are counted.
    There are 4 options:
    - rising or falling edge: One of the following edge type will be selected: rising or falling
    - rising edge: Rising edge required
    - falling edge: Falling edge required
    - both edges: Both edges (rising and falling) required
Initialization - Initial settings (after power-on or reset).
- Enabled in init. code - The bean is enabled after a power-on or reset (in initialization code).
The following items are visible only if integration of Processor Expert with Simulink supported.
- Bean name - Name of the bean.
- Edge - Type of signal edges that are counted.
  There are 4 options:
  - rising or falling edge: One of the following edge type will be selected: rising or falling
  - rising edge: Rising edge required
  - falling edge: Falling edge required
  - both edges: Both edges (rising and falling) required
- Mode - Counting mode.
  Simple counter - counter counts up to 256 cycles and then overflows.
  Repetitive - counter counts to a given number of cycles and after that it invokes OnEnd user event.
- Iterations before action - Number of cycles to invoke the OnEnd event. (Property is only available when the bean is in Repetitive mode)